Safety & Quality
Where safety meets performance
Blade repair is technical work done at height. Our safety and quality practices are designed so every task is planned, every person is qualified for the work, and every repair can be verified.
Safety
Operational discipline on every site
Our safety approach applies the same way on a single-turbine repair as on a multi-month campaign.
Safety-first field operations
Work starts only when the hazards of the task, the site and the day's conditions have been assessed and controlled.
- Daily toolbox talks and pre-task briefings
- Weather and wind-speed limits applied to every access method
- Stop-work authority for every person on site
Working-at-height risk management
Blade work is high-consequence work. Access, fall protection and rescue are planned before anyone leaves the ground.
- Access method selected for the task and site
- Written rescue plan for each work location
- Equipment inspected before use and on a documented schedule
Training and competency verification
Technicians are assigned only to work they are qualified and experienced to perform.
- Qualifications checked against project and site requirements
- Training records available to customers on request
- Repair experience matched to the damage categories in scope
Job safety analysis
Each scope gets a task-specific JSA, reviewed with the crew and updated as conditions or methods change.
- Hazards identified by task step
- Controls agreed and assigned
- Reviewed whenever the task or conditions change
PPE requirements
PPE is specified by task, including the respiratory, eye and skin protection that composite work and resin systems require.
- Fall protection and rescue equipment
- Respiratory protection for grinding and coatings
- Chemical-resistant gloves and eye protection
Customer and site procedures
DBS crews work within the customer's own safety management system and site rules.
- Site inductions and permit-to-work compliance
- Lockout/tagout coordination with site personnel
- Incident and near-miss reporting to the customer
Quality
Repairs you can verify
A blade repair record should let an engineer understand exactly what was found, what was done and with which materials. Our quality controls are built around that record.
- 01
Quality control procedures
Hold points for damage removal, laminate preparation, layup and cure, checked before the next step proceeds.
- 02
Repair documentation
Before, during and after photographs; damage location by blade and station; dimensions and repair method.
- 03
Traceability
Materials, batch numbers, shelf life, mixing ratios and ambient conditions recorded for each repair.
- 04
Reporting
Daily progress reports during the work and a closeout package at the end, in the customer's required format.
Management systems
Quality Management & Continuous Improvement
DBS is developing formal management systems and procedures to support consistent quality, accountability, and operational performance.
Lessons from every project feed back into our procedures. Customer feedback, inspection findings, near-miss reports and closeout reviews are used to update work instructions, training and crew planning.
Certification and qualification status
- ISO 9001 · Quality management
- In development
- Not yet certified. This status will be updated when certification is completed and verified.
- ISO 14001 · Environmental management
- In development
- Not yet certified. This status will be updated when certification is completed and verified.
- GWO, IRATA, SPRAT
- Individual
- Held by individual technicians. Certificates are verified for each project and provided to customers on request.
- OEM training and authorizations
- Individual / per project
- Held by individual technicians where applicable. DBS does not claim company-level OEM authorization.
Request for Quote
Need our safety documentation for prequalification?
Contact us to request safety program information, insurance certificates and vendor documentation for your onboarding process.
